Rule · 27DA
Bilge sump
No float switch installed yet — the pump has no automatic redundancy until that task is done.
Verify onboard: Verify 1 1/8 in discharge hose and through-hull match pump capacity.
Last serviced
Not recorded
Open issues
1
Open tasks
0
Parts on record
1
Interval: Test frequently; clean filters/strainers
Every logged job that touched this component.
No service logged yet
The first entry starts this component's paper trail.
Planned and completed work for this component.
Nothing planned
No open or past tasks reference this component.
Problems and conflicts on record for this component.
Task list calls for float-switch installation and filter cleaning; auto-sensor status of the Rule 27DA is unverified.
Next step: Install the float switch, test manual and automatic modes, clean strainers, verify the 1 1/8 in discharge run.
Part numbers on record — check confidence before ordering.
1 1/8 in ID reinforced marine hose
Match pump capacity and through-hull.